Capabilities / Sensor interfaces
Turning the physical world into numbers.
Precision front ends that read pressure, temperature, humidity and touch, and turn them into clean, calibrated data.
Overview
Why it matters.
A sensor on its own only produces a tiny change: a capacitance that shifts by a fraction, a resistance that drifts by a hair, a voltage buried in noise. The sensor interface is the circuit that notices that change and turns it into a number software can trust.
It is also where most of a measurement goes wrong. Noise, drift, offset and temperature all creep in at this first step. We design our interfaces to catch them there, so the number that comes out is the number the world actually put in.
What we design
The building blocks.
Capacitive interfaces
Read capacitive sensors for pressure, humidity and touch.
Resistive interfaces
Read resistive sensors such as temperature elements and strain gauges.
Low-noise amplifiers
Lift small signals above the noise before anything else touches them.
Temperature sensing
On-chip temperature measurement, used directly and to correct every other reading.
Calibration
Trim and correction that remove part-to-part differences after manufacture.
Touch sensing
Arrays that read pressure, slip and approach across a surface.
Design priorities
What we design for.
01
Accuracy
The reading matches the world, not the circuit.
02
Low noise
Small signals stay clean.
03
Low drift
Readings hold over time and temperature.
04
Low power
Measure often on a small battery.
In our chips
Where you'll find it.
Need this in your chip?
Tell us what your product has to sense, time or control.
Technologies