2D Geometry

Capabilities / Sensor interfaces

Turning the physical world into numbers.

Precision front ends that read pressure, temperature, humidity and touch, and turn them into clean, calibrated data.

CategorySensing
MeasuresPressure, temperature, humidity, touch, force
Found inAtmospheric and robotics chips

Overview

Why it matters.

A sensor on its own only produces a tiny change: a capacitance that shifts by a fraction, a resistance that drifts by a hair, a voltage buried in noise. The sensor interface is the circuit that notices that change and turns it into a number software can trust.

It is also where most of a measurement goes wrong. Noise, drift, offset and temperature all creep in at this first step. We design our interfaces to catch them there, so the number that comes out is the number the world actually put in.

What we design

The building blocks.

Capacitive interfaces

Read capacitive sensors for pressure, humidity and touch.

Resistive interfaces

Read resistive sensors such as temperature elements and strain gauges.

Low-noise amplifiers

Lift small signals above the noise before anything else touches them.

Temperature sensing

On-chip temperature measurement, used directly and to correct every other reading.

Calibration

Trim and correction that remove part-to-part differences after manufacture.

Touch sensing

Arrays that read pressure, slip and approach across a surface.

Design priorities

What we design for.

01

Accuracy

The reading matches the world, not the circuit.

02

Low noise

Small signals stay clean.

03

Low drift

Readings hold over time and temperature.

04

Low power

Measure often on a small battery.

In our chips

Where you'll find it.

Need this in your chip?

Tell us what your product has to sense, time or control.

Technologies

The other building blocks.